13 Tooth Bevel Gear (2 pack)

Specifications:

• Diameter: M3
• Diameter - Thread Size: M3 - 0.5
• Drive: Hex
• Drive Size: 2.5mm
• Finish: Zinc
• Length: 5 mm
• Thread: Coarse
• Thread Size: 0.5
• Type: Socket Cap Screw

Specifications:

• Material: 6061-T6 Aluminum
• Number of teeth: 26
• Step File

The Motor Mount Plate is used with the Maverick 12V DC Gear Motor  (Part# 75001) to attach it inside the anyone of the U Channels 76010 to 76018. This is an example of a chassis with 4 motors mounted inside the U-Channel using a Motor Mounting Plate.

• Step File

The 20 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts. 

Specifications:

• 20 Tooth Timing Pulley
• 6mm Bore 
• Material: 6061 T6 Aluminum
• Step File

Our SpinTake has three bore options, making it a viable part for both FRC and FTC! This product is ideal as an intake "wheel" for picking up game pieces of varying shapes. Made from natural rubber, the SpinTake is flexible, yet firm. Its unique shape also allows it to be oriented to stay within the robot frame perimeter initially but can reach outside just by spinning. These work in a similar fashion to surgical tubing fingers on an axle, but are easier to implement and provide a cleaner look with more consistent results. 

The Hex Bore options are designed to be an interference fit on their associated Hex Shafts. This means it will be a tight press to install but will resist slipping under load. 

Specifications

• Bore: 5 mm Hex, Nub Bore, 1/2 in. Hex
• Length (Diameter): 3 in.
• Material: Natural Rubber
• Thickness: 0.5 in.

This gear is used as the input pinion gear for the EVO Shifter. This gear is a tight press fit onto a CIM gear, and requires at minimum a 3-ton arbor press to install. If a CIM motor with this gear pre-installed interests you, check out am-0255_15T. 

Specifications:

• Tooth Count: 15
• Diametral Pitch: 32
• Pressure Angle: 20
• Pitch Diameter: 0.469"
• Face Width: 0.531"
• Thickness: 0.75"
• Material: 1117 Steel
• Bore: 0.312" Round (7.92mm) This is a press fit onto the CIM Motor (am-0255)
• Weight: 0.019 Lbs

The 6mm Shaft hub is used to connect any Studica wheel and the Studica motor or any motor with a 6mm shaft.

Specifications:

• Material: 6061-T6 Aluminum
• 6mm ID
• Hole pattern for connecting to structure
• Step File

The Studica Light Weight Shaft Hub is used with the 6mm D shafts. It has a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

Specifcation:

• Material: 6061-T6 Aluminum
• 6mm D Shaft ID
• M3 tapped hole pattern for connecting to structure
• Step File

These gearboxes are designed with the same 37 mm diameter as the original 60:1 gearbox, while using the same 6 mm D-shaft and alignment pins, so getting the additional speed you need is a breeze.