Pneumatics
This is a brass plug for a 1/4" NPT port.
Specifications:
This is a Nylon plug for a 1/4" NPT port.
Specifications
This is a pneumatic meter-out flow control valve. The port is a 1/8" NPT male thread, and 1/4" diameter tube can be pressed in to the push-to-connect fitting.
Meter-out allows for the flow to be controlled in one direction, while the opposite flow is not restricted.
This is a brass plug for a 1/8" NPT port.
Specifications:
This is a Nylon plug for a 1/8" NPT port.
Specifications
This is a 20 meter length of black, polyurethane pneumatic tubing.
Specifications:
This is a polypropylene plastic air tank accumulator holding 36.0 cubic inches (~590ml) up to a pressure of 125 psi and a burst rating of 500 psi.
This tank has 1/4" NPT ports (2).
Specifications:
This is a steel ball valve, with a large plastic handle. On mobile robots, this can act as a vent valve. It has two ports, one being a 1/4" NPT male and one being a 1/4" NPT female port
Specifications:
Three (3) straight 1/8 NPT fittings (or right angle 1/8 NPT fittings) are NOT
INCLUDED with this part, but are needed to connect tubing to this valve.
Specifications:
This is a fitting intended on remotely-mounting a pressure gauge. This
fitting can be mounted to a panel, through a 9/16" hole, and it has a 1/8" NPT
female port.
Specifications:
This is a brass adapter fitting with a male 1/8" NPT thread and a female 1/4"
NPT port.
This fitting helps out an application when a device with a 1/4" NPT male thread
needs to fit into a 1/8" NPT female port.
Specifications:
This is a straight line Union Hex Nipple with 1/4" NPT Thread on both sides.
Specifications:
This is a straight line Union Hex Nipple with 1/8 NPT Thread on both sides.
Specifications:
This is a Nickel plated Brass cross union with three (3) Female connections
with 1/8 NPT thread and one (1) male connection at 1/8 NPT.
This part can replace heavier brass manifold pieces and makes your pneumatic
system lighter.
Specifications:
This is a straight line Union Hex Nipple with 1/4" NPT Thread on both sides.
Specifications:
This is a straight line Union Hex Nipple with 1/8 NPT Thread on both sides.
Specifications: