Close
Main Categories
    Filters
    Preferences
    Search

    PWM Wire / Cable Making Kit

    Create your own custom length PWM cables with this kit. This kit allows you to make ends for custom length PWM cables, with a single cable up to 10ft long.  Not shown in the picture is that there is plenty of extra pins in case you damage a few, or want to remake.

    Kit Includes:

    • 1 - 10ft of 22AWG Bonded PWM cable, Black/Red/White (am-3162)
    • 1 - PWM Male Connector (25 Housings, 100 Pins) (am-0943a)
    • 1 - PWM Female Connector (25 Housings, 100 Pins) (am-2814a)
    MFR Part #: am-2868
    $55.00
    Write your own review
    • Product can be reviewed only after purchasing it
    • Only registered users can write reviews
    • Bad
    • Excellent
    Customers who bought this item also bought

    6 Gauge 12 Inch Battery Cable - Flexible EPDM Insulation

    #am-4483
    $25.00
    (26 In stock)

    Tip-to-tip length is approximately 12.6 inches. Want it longer or shorter? We offer this cable in custom lengths! Both end connectors are crimped with a 6-ton pneumatic crimping tool. One end has connections to attach to the battery and the other has an SB50 Anderson Connector. This cable is resistant to oil, most acids, grease, and even abrasion! That's a TOUGH cable.

     

    Which do you prefer a stiff cable or a flexible cable? No matter your choice we have the best option in either camp. PVC insulated cables create a stiff wire route maintaining shape for repeatable connections. EPDM jacketed cables cand bend and twist to accommodate tight spaces and small places.

     

    Specifications

    • Connector : SB50, 1/4 in. Ring Terminal
    • Gauge: 6
    • Insulation: PVC or EPDM
    • Operating Temperature: 257°F to -59°F
    • Stranding: 263 inside EPDM Jacketed Wire
    • Voltage: 60V Max
    • Wire Type: Stranded

    6 Gauge 12 Inch Battery Cable - Stiff PVC Insulation

    #am-0009
    $26.50
    (10 In stock)

    Tip-to-tip length is approximately 12.6 inches.

    Compact Elevator Bearing Kit, 2 Stage Tube Size: 2x1 in.

    #am-4875_8
    $299.00
    (0 In stock)

    The AndyMark Compact Elevator system is our next generation line of products to help FIRST Robotics Competition teams create high quality, reliable and robust linear motion mechanisms, such as an elevator or extension arm. The core of this system are the Bearing Kits, which are designed to be easily integrated into your robot design, and provide smooth rolling motion for your linear mechanisms. The primary load direction is supported by high strength 13mm Cam Follower needle bearings installed within machined aluminum blocks for a compact but robust bearing solution. The secondary load (or lateral loads, in a traditional FRC elevator,) is supported by 695ZZ ball bearings to keep your linear mechanisms moving and aligned. The 6061-T6 aluminum blocks have thoughtfully designed features integrated into them, including alignment grooves to help locate and support them along box tubes, as well as nut pockets machined in to support the M5 nylock nuts that retain the Cam Follower bearings.