The 38mm Omni Wheel was designed as an odometry wheel that can fit inside most channel sizes. For ease of use, three cores were designed to fit 6mm D-Shaft, 5mm Hex Shaft, and 7mm Hex Shaft. The wheel is open for easy use in any ecosystem with the provided different-sized cores.
Specifications:
Includes,
Made of aluminum, the Studica Clamping Shaft Hub is used with flex and drive wheels
Specifcation:
Use this 10-cell, 12-volt rechargeable pack to bring long-lasting power to TETRIX® motors and electronics. This 3,000 mAh NiMH pack features a built-in, 20-amp replaceable fuse for safety.
(THIS BATTERY IS FTC LEGAL)
The Studica Light Weight Shaft Hub is used with the 6mm D shafts. It has a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
This 20 Amp fuse is used in FIRST Tech Challenge batteries and the FIRST Robotics Competition Power Distribution Panel (am-2856). Specifications:
Φ29.0mm*16.0mm thick6*M3 thread tapping through(including 2*M3 thread for M3 SHCS)Φ6.0mm D holeAL6061-T6
Used with the Intake Kit to create various intake system with various lengths.
This is the cable designed for the encoder that is pre-attached to the NeveRest Series of motors and gearmotors. It has a connector on the opposite end to directly interface with the REV Expansion Hub or the REV Control Hub.
2019 Update:
The 'a' version of this cable as the encoder channels swapped so that the encoder counts in the same direction as the output shaft spins. This simplifies the usage of the encoder with the various programming languages for FTC!
This versatile rotary sensor offers a comprehensive solution for measuring both relative and absolute positions, thanks to its ABI quadrature output and absolute position pulse output capabilities. The encoder is thoughtfully designed with a standard 3/8-inch Hex Through Bore, complete with strategically placed mounting holes to seamlessly integrate into various multi-channel systems.
Enhancing its adaptability further, the package includes interchangeable inserts, allowing you to effortlessly convert the 3/8-inch hex to a 6mm D-Shaft, 5mm hex, or 7mm hex, providing you with exceptional flexibility for your application needs.
Great for use in an FTC Odometry system along with our 38mm omni wheel.
The Intake Kit can be used to create intake systems and is ideal for the FIRST Technical Challenge (FTC) and World Robotics Olympiad (WRO). Used with the Silicone Rubber Tubing #76410
The Studica 30T Servo 25T Spline Gear is used with the Studica Multi-Mode Smart Servo or Studica Multi-Mode Smart Servo 200.