This shaft was originally used in our After Burner PTO. This shaft may find a use in your custom gearbox application. This shaft is intended to be used as a part of a shift mechanism. The shaft has a 0.188 in. long through-slot to be used with a shift assembly.
am-3347 Shift Shaft for Afterburner.STEP
am-3347 Shift Shaft for Afterburner.PDF
Don't see what you need?
These adapters are intended to be a high strength solution to adapt the Falcon Spline to any product that has a 1/2 in hex bore. This product includes the correct size washers to retain items along the hex shaft, as well as a thread-patch 8-32 screw to be used in conjunction with spacers included with the Falcon 500 motor to retain motion hardware.
Miter gears are a special class of bevel gears where the shafts intersect at 90° and the gear ratio is 1:1. This miter gear has a .500" hex bore, making it perfect for interfacing with many popular products in the competition robotics marketplace.
Miter gears are a special class of bevel gears where the shafts intersect at 90° and the gear ratio is 1:1. This miter gear has a 8mm bore with a 2mm keyway, fitting perfectly on a CIM motor shaft.
This shaft originally was the secondary output for the RocketBox PTO. This shaft connected the drive motors to the winch instead of the wheel output. This shaft can find a home in your custom gearbox design.
This spool kit makes up part of our Afterburner Winch Kit (am-3344). If you wish to adapt your own winch system you can simplify the process by using this off the shelf spool kit. The winch drum diameter is 1.426".
Loose Hardware within this Product: