Designed to join together two CAN devices in series. This makes it easy to break the connection to remove robot mechanisms or to help extend the length of your connection.
This design orients the connector parallel to the mounting surface for a strain-reduced wirepath. It also features a simple 1 in. mounting pattern perfect for #10-32 screws for easy mounting on the robot. The board has no active traces near the mounting holes, so you can easily just match-drill through the board to translate the hole pattern to your robot with ease! We’re also now offering the correct resistor for CAN setups with FRC control system components (Such as the Talon SRX, Victor SPX, etc) when you are not using the Power Distribution Panel. Perfect for those Hero control system setups for non-FRC use.
am-4130 CAN Connector.STEP
am-4130 CAN Connector.PDF
am-0516 0375IN ID bearing, shielded (R6ZZ) REV2.PDF
am-0516 0.375'' id bearing, shielded (R6ZZ).STEP
This is a 1/4 in. round bore bearing that is unflanged. The Shielded Ball Bearing is a great way to make things spin fast!
This is a 1/4 in. round bore bearing that is flanged. The Shielded Ball Bearing is a great way to make things spin fast!
3/8" id shielded, flanged ball bearing
0.75" x 0.85", nylon, 0.75" od, 0.38" id, 0.85" thick, white
#35 Half Link. Also known as #35 Offset Link.
#35 Connecting Link (Master Link)
#25 Half Link. Also known as #25 Offset Link.
#25 Connecting Link (Master Link)