This is a blank cover fitting in where a valve would mount on the CKD manifold (am-3982). All 4 ports of the manifold are required to be covered by either a solenoid or by this cover.
Pneumatic fitting with M5 threads and 1/4" push-in tubing port This fitting screws into a CKD single or double solenoid valve. Specifications:
This is a pneumatic push-to-connect union tee fitting. All three of the ports are push-to-connect 1/4" fittings. Specifications:
This is a push-to-connect "Y" fitting. Specifications:
These double acting single rod stainless steel cylinders are a solid choice when you want air actuated motion. These cylinders have a strong 0.75 in. thick bore and are available in multiple stroke lengths.
Now, you can put your CKD valves on a light weight 4-bank aluminum manifold.
This is a hex nipple brass fitting, with one end being 1/4" NPT and the other being 1/8" NPT port. The intent of this part is to connect the air compressor (pump) to the aluminum manifold within the Pneumatics Base Kit. Specifications:
This is an single solenoid, air-piloted, compact valve made by CKD. It's great for efficiently providing air to a small to medium sized actuator on mobile robots.
In order to make this work, you will also need three (3) M5 fittings (NOT INCLUDED) and some tubing (also NOT INCLUDED).
Link to CKD valve catalog
CKD part number: 4GA110R-M5-4
This is an double solenoid, air-piloted, compact valve made by CKD. It's great for efficiently providing air to a small to medium sized actuator on mobile robots.
CKD part number: 4GA120R-M5-4
This is an air pressure switch with a factory preset setting of 115-120 psi. This switch is able to send a signal to a robot controller, which can then tell a pneumatic compressor (air pump) to stop operating.
Guide(s)
am-2006 Data Sheet.pdf
This is a brass relief valve used in low-volume air tanks and pumps to retard excessive pressure buildup. Specifications: