Specifically designed for FTC, (though not limited to FTC), this remarkable system is a quick way to execute a controlled extension. Each stage of the Compact Linear Slide is controlled by a pulley system that can be rigged to power both extension and retraction.
Components Included in the base kit (am-4846):
Each Additional Stage Includes:
am-4846, 4850, 4851 Compact Linear Slide Assembly Guide.pdf
am-4846 Compact Linear Slide (1 Stage).STEP
am-4850 Compact Linear Slide (2 Stage).STEP
am-4851 Compact Linear Slide (3 Stage).STEP
am-4846 Compact Linear Slide (1 Stage).pdf
am-4850 Compact Linear Slide (2 Stage).pdf
am-4851 Compact Linear Slide (3 Stage).pdf
The Studica Flat Bracket is a very strong 3mm x 40mm wide. As with the other Studica Robotics building components, it has the common hole pattern which makes it easy to connect to other structure with very little or no additional machining required. You can easily connect to other channel, extrusions, bushings, bearing, mounting brackets and more so you can quickly assemble and disassemble robots and automated systems.
The Studica Fast Multi-Mode Smart Servo features all-steel gears and large amounts of torque. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Fast Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
The Studica Linear Servo RC Actuator 140-200 is a new Servo motor which has a stroke of 140mm. It works the same way as the any standard rotary servo but in a linear movement. It uses the same 2.54mm Dupont 3-Pin Female wire connector and can be controlled with an RC receiver or any device that controls a servo. Includes mounting brackets.
This linear motion shaft of 8 mm in diameter and 496 mm in length is chrome plated and case hardened, and is suitable for use with slide units in linear motion applications. The high-carbon steel shaft is chrome plated for corrosion resistance, case hardened for wear resistance, and precision ground for consistent ball bushing radial clearance. Used with WSR Linear Motion Slide Unit 8mm(ID) -2 pack
This linear motion closed type slide unit has an 8 mm inside diameter. The slide unit, designed to carry a component, has a housing with a flat mounting face and four tapped bolt holes, and circle clips at each end to retain the ball bushing. Ball in the cage loop to run a smooth ball guide surface to ensure even if high-speed operation, low noise. Used with WSR Linear Motion Shaft - 8mm(D) x 496mm(L)
Our improved and stronger 12-volt DC motor with 100 rpm and 708 oz-in. of torque. The motor features a built-in, high-resolution Hall effect encoder for precise motor control and comes with an encoder cable.
A 61:1 gearbox comes standard.
No Load RPM
No Load Current
Output Counts per Revolution of Output Shaft (cpr) 1,464 pulses
This motor is not FTC Compeition Legal
The 400mm Rail and Block Set will provide precision and low friction sliding for all your robot applications.
This Tool Set includes everything you need to assemble the 2023-2024 FIRST Tech Challenge game, CENTERSTAGE℠ presented by Raytheon Technologies.
We also offer a CENTERSTAGE℠ Tape Set.
Components in am-5100_tool:
This kit can be used in addition to the Compact Linear Slide to add length to the extension limit of the device.
This Heat Shrink Assortment kit is perfect for outfitting your shop with a comprehensive selection of shrink tube. It contains many lengths and gauges to be used.