This GT2 (also called 2GT) timing belt has a 2mm Pitch and 6mm width
Specifications:
The Studica Multi-Mode Smart Servo features all-steel gears and large amounts of torque. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
Type: Metal Brush Motor Horn Gear Spline: 25T (5.9mm) Size: 40mm x 20.1mm x 38.3mm Weight: 65g Maximum Speed: 62RPM at 6V Stall Torque: 20kg.cm at 6V Voltage: 6-7 4V Cable: 22AWG, 75cm
The 20 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 40 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
These gearboxes are designed with the same 37 mm diameter as the original 60:1 gearbox, while using the same 6 mm D-shaft and alignment pins, so getting the additional speed you need is a breeze.
The Studica 30T Servo 25T Spline Gear is used with the Studica Multi-Mode Smart Servo or Studica Multi-Mode Smart Servo 200.
The 6mm diameter D -Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.
Specifcation:
Used with the Intake Kit to create various intake system with various lengths.
Used with Maverick DC Motor with 6mm shaft and all 6mm D-Shaft Axels. Matching belt 10mm Timing Belt, # 76233.
Includes two 5mm Bore, 10 Tooth Aluminum Pulleys and one 1M XL Timing belt
This GT2 (also called 2GT) timing belt has a 2mm Pitch, 6mm width, and open 1000mm in length. Use any of the GT2 pulleys from Studica and the clamp kit.
The GT2-6mm Timing Belt Clamp w/Set Screw is used with all the GT2 belts.