Pneumatique
This is an elbow fitting with 1/4" NPT Thread and a 1/4" press-in-connector.
Specifications:
This is a push-to-connect "Y" fitting.
Specifications:
This is a pneumatic Y connection with two 1/4" push-to-connect fittings and
one 1/8" NPT thread end.
Specifications:
This is a Nickel plated Brass "Y" union with two (2) Female connections with
1/8 NPT thread and one (1) male connection at 1/8 NPT.
Specifications:
Now, you can put your CKD valves on a light weight 4-bank aluminum manifold.
This is a hex nipple brass fitting, with one end being 1/4" NPT and the other
being 1/8" NPT port. The intent of this part is to connect the air compressor
(pump) to the aluminum manifold within the Pneumatics Base Kit.
Specifications:
This is a miniature pressure gauge with two 1/4 in. push to connect fittings for in line installations. It is perfect for lightweight pneumatic systems where you need to mount a pressure gauge in line with a tubing run. This pressure gauge is significantly reduced in volume and weight compared to the classic gauges used in FRC. This lets you take advantage of every last cubic inch and ounce on your robot.
This is an all in one in-line pressure regulator and low pressure side gauge perfect for lightweight pneumatic systems where you need to mount a regulator somewhere downstream in the system.
This is a miniature pressure regulator with 1/4 in. push to connect fittings perfect for lightweight pneumatic systems where you need to mount a regulator downstream in your pneumatics system. Combining push to connect fittings with the miniature regulator makes installation anywhere in your robot fast and simple. This regulator is significantly reduced in volume and weight compared to the classic regulators used in FRC. This lets you take advantage of every last cubic inch and ounce on your robot.
Be sure all your threaded pneumatic connections are sealed properly with this
teflon tape. Standard grade PTFE tape used in all your robot pneumatics.
Specifications:
This is the next step in a pneumatics package, which gives you all the parts you need for an entire system to push 7" stroke cylinders (included). And creates pressurized air in a safe, manageable manner for mobile robots.
Entire list of Hardware:
This kit of parts makes up a system which creates pressurized air in a safe, manageable manner for mobile robots.
This is an assortment of lightweight parts picked specifically to work well together in an efficient manner. All of these parts together weigh under 6 pounds. These parts collectively make up a pneumatic system, sending air out to the valves and cylinders. These are all of the parts you need to get controlled, pressurized air sent to your valve(s) of choice.
Hardware:
NOTE: This product is not included in any Sales or Discounts.
This is for the Pneumatic Control Module (aka PCM) being used in the 2015 through 2021 FIRST Robotics Competition Kit of Parts.
For an overview of the 2020 Controls system, please see: https://wpilib.screenstepslive.com/s/currentCS/m/kop.
The Pneumatic Control Module (aka PCM) from Cross the Road Electronics provides an easy all-in-one interface for pneumatic components.
This is a pneumatic push-to-connect male elbow fitting. The port is a 1/8" NPT male thread, and 1/4" diameter tube can be pressed in to the push-to-connect fitting.
Specifications:
This is a pneumatic push-to-connect male straight fitting. The port is a 1/8" NPT male thread, and 1/4" diameter tube can be pressed in to the push-to-connect fitting.
Specifications:
This is a pneumatic push-to-connect male straight fitting. The port is a 1/4" NPT male thread, and 1/4" diameter tube can be pressed in to the push-to-connect fitting.
Specifications: