This is a brass relief valve used in low-volume air tanks and pumps to retard excessive pressure buildup.
This is a brass adapter fitting with a male 1/8" NPT thread and a female 1/4" NPT port. This fitting helps out an application when a device with a 1/4" NPT male thread needs to fit into a 1/8" NPT female port. Specifications:
This is a handy cable, positioned on a robot, to connect the Power Distribution Panel to a battery. The cable is made of 6 gauge multistrand wire while the connectors are securely crimped and protected with heat shrink tubing. The tip-to-tip length is approximately 20 inches. Also, this cable is used in the Robot Power Cable Kit. Both end connectors of each cable are crimped with a 6-ton crimping tool. Specifications:
Included Hardware:
This is a Nickel plated Brass cross union with three (3) Female connections with 1/8 NPT thread and one (1) male connection at 1/8 NPT. This part can replace heavier brass manifold pieces and makes your pneumatic system lighter. Specifications:
This is a handy cable to connect the 120 amp breaker to the Power Distribution Panel. The cable is made of 6 gauge multi-strand wire while the connectors are securely crimped and protected with heat shrink tubing. The tip-to-tip length is approximately 5 inches. This cable is used in the Robot Power Cable Kit. Both end connectors of cable are crimped with a 6-ton pneumatic linkage crimping tool. Specifications:
VIAIR 90C compressor (air pump) offers a light duty solution for smaller air requirements. These compact compressors and are meant to fill no larger than a 1.0 gallon air tank. VIAIR part number 00090 Specifications:
Hardware:
Fill Rate
Products to be used on:
For VIAIR compressor warranty replacements contact Ryan Shaw.
Do you have a hard time finding some strong hex stock aluminum? We have it! This is 7075 series aluminum, which is great for use in transmission shafts.
Specifications:
This is a Nickel plated Brass "Y" union with two (2) Female connections with 1/8 NPT thread and one (1) male connection at 1/8 NPT. Specifications: