Fermer
toutes catégories
    filtres
    préférences
    Rechercher

    Servo Standard Front

    The Servo Standard Front Mounting Bracket is one option to mount the Multi-Mode Smart Servo (75002) to the Studica building structure.

     

     

    # Pièce: 76144
    $6.24
    Disponibilité: 696 en stock
    Écrivez votre propre commentaire
    • Le produit peut être examinée que après l'achat
    • Seul les utilisateurs enregistrés peuvent écrire une critique
    • Mal
    • Excellent
    Les clients ayant acheté cet article ont également acheté

    12 AWG Bonded Cable PP45 Powerpole to Bare Wire

    #am-2590
    $10.00
    (0 En stock)

    This cable can be used in many ways, a power cable for the Gorgon Flex, or from a Speed Controller to a CIM motor. One end connectors are crimped with PowerPole Connectors, two crimps and a black and red housing are shipped with this cable. Tip-to-tip length is approximately 24 inches. 

    Specifications:

    • Weight: pounds
    • Length: Approximately 24 inches
    • Connector Type: Anderson PowerPole PP45
    • Gauge: 12 bonded

    Anderson PowerPole to JST VH

    #am-3732
    $5.39
    (En stock)

    Use the Anderson Power Pole to 2-pin JST VH Adapter Cable to connect your existing motors to the REV Robotics Expansion Hub.

    Connections:

    • JST VH
    • Anderson Power Pole

    Intake Hub Kit

    #70210
    $10.95
    (1702 En stock)

    The Intake Kit can be used to create intake systems and is ideal for the FIRST Technical Challenge (FTC) and World Robotics Olympiad (WRO). Used with the Silicone Rubber Tubing #76410


    Specifications:

    • Main piece
      • hex width: 20.78mm*10.0mm thick
      • 6*M6 tapped holes
      • 1*M4 tappped hole for M4 set screw
      • 6.0mm Diameter D Hole
      • Material AL6061-T6
      • Φ7.5mm*14.0mm
    • Pins
      • 6PCS in a pack
      • M6*4.0mm thread
      • Material SS303
    • Step file

    Servo Arm Extended

    #76150
    $8.32
    (En stock)

    The Studica Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

     

    Specifcations:

    • Spline: 25 Tooth, 3.8mm deep
    • Length: 56mm
    • Width: 14mm
    • Height: 7.8mm
    • Material: 6061-T6 Aluminum
    • Step File

    Motor Mount Clamp Kit

    #76141
    $15.27
    (35 En stock)

    Use the Motor Mount Clamp kit when fastening motors on body and attaching kit to channel and other structure.

     

     

    XT30 (MH-FC) to Tamiya (MH-FC) Cable

    #70179
    $5.54