TTS™ CNC Operator Set with Tormach Tool Assistant

The TTS-R8 Adaptor Collet is an R8 collet with modified length that allows for mounting of all TTS tool holders in R8 taper spindles

1100M Printed Owners Manual

Maximizes productivity with combination control of feed and positioning on all 4 axes (X, Y, Z, and A)

The Passive Probe Kit is an economical probe that quickly and automatically sets work offsets using PathPilot’s integrated probing routines.

PCNC 440 Chip Pan Kit.

PathPilot Controller for Tormach PCNC 1100 Mill, PCNC 770 Mill, PCNC 440 Mill and 15L Slant-PRO Lathe.

• Required for Tormach 15L Slant-PRO lathe and PCNC 440 Mill
• Preloaded with PathPilot^®2.0
• Includes all applicable cables
• Configurable for either 115 VAC or 230 VAC
• Covered by 12 month Tormach Warranty

NOTE: replacement for PN 35286

Controller is NOT compatible with 770M/MX or 1100M/MX Mills, 1300PL Plasma Table.

58 Piece Pro Quality Steel Clamp Kit.; Includes assortment of T-nuts, Studs, Strap Clamps, and Flange Nuts.

• T-nuts fit standard 3/8" T-slots.
• 5/16 in.-18 Studs

The Power Drawbar Kit supplies a pneumatic power drawbar that increases productivity and efficiency through push-button tool changes - for use with and without 440 ATC

Eliminate the need to hand-tighten your drawbar and install this Power Draw Bar on your PCNC 770 for lightning-fast tool changes with the push of a button.

The power drawbar is designed for use with the Tormach Tooling System (TTS), but easily pivots away to allow manual tightening of the drawbar if necessary for conventional R8 tooling.

• Requires 90 psi Air Supply (FRL unit recommended)
• Designed for use with Tormach Tooling System (TTS) toolholders
• Control Pendant (Standard) or Foot Pedal (Sold Separately) actuation
• Multi-stack air-over-air pneumatic cylinder ram actuation
• Does not load the Spindle Bearings
• Easily Pivots for Manual drawbar tightening for R8 tooling
• Integrates with Tormach ATC (sold separately)
•  

The Power Drawbar kit includes pneumatic cylinder assembly stack, drawbar, electronic control circuitry, push-button pendant, and all necessary pneumatic tubing and electronic wiring.