This 12 tooth pinion gear is designed to fit onto an AndyMark RedLine Motor (am-3775) and other motors with a 5 mm output shaft to interface with spur gearboxes such as the DeCIMate (am-3745), EVO Slim for RedLine and EVO Shifter for RedLine.
This gear is used as the input pinion gear for the EVO Shifter. This gear is a tight press fit onto a CIM gear, and requires at minimum a 3-ton arbor press to install. If a CIM motor with this gear pre-installed interests you, check out am-0255_15T.
Specifications:
Tooth Count: 15
Diametral Pitch: 32
Pressure Angle: 20
Pitch Diameter: 0.469"
Face Width: 0.531"
Thickness: 0.75"
Material: 1117 Steel
Bore: 0.312" Round (7.92mm) This is a press fit onto the CIM Motor (am-0255)
Miter gears are a special class of bevel gears where the shafts intersect at 90° and the gear ratio is 1:1. This miter gear has a .500" hex bore, making it perfect for interfacing with many popular products in the competition robotics marketplace.
Miter gears are a special class of bevel gears where the shafts intersect at 90° and the gear ratio is 1:1. This miter gear has a 8mm bore with a 2mm keyway, fitting perfectly on a CIM motor shaft.
Introducing FlexHub, designed by engineers from iR3 Creative Engineering, from Orlando, Florida. FlexHub is a modular gear & hub solution from iR3 Creative. The concept is pretty simple. There is a hub, there is a gear, there are two retaining rings. Put them together into your assembly. If the gear ratio / shaft size / output / whatever isn’t working rinse and repeat with a new hub or gear