QTY 4 Crowned Roller Pulleys

Soyez le premier a tester ce produit

These crowned roller pulleys are designed to fit over 1.25" OD tubing. They are made from 70A durometer TPE and are great for keeping flat urethane belting centered on your tubes or for simply intaking game pieces using the rollers themselves.

Holes are included for 5/32 rivets that can be used for retention on tubes. Rivets nest nicely within the TPE material, leaving the rivet head slightly below the rest of the roller material.

2.875" in length, 1.6" OD at center

# Pièce: TTB-0096

$23,17

Quantité:

Commentaires

Écrivez votre propre commentaire

Le produit peut être examinée que après l'achat
Seul les utilisateurs enregistrés peuvent écrire une critique

A également acheté

Aluminum Round Groove Pulley

#ELEV-PULLEY-002

$9,95

( 0 En stock)

This is the same pulley used on the Thrifty Elevator Dyneema Pulley Kit. Works great with 1/8" dyneema rope and has a 1/4" ID bearing in the center allowing teams to use a bolt to easily mount it and have it spin freely.

1.15" OD with a .365" groove will let this pulley work with other rope options as well.

4 Gauge Robot Side Red & Black Power Cable

#am-3851

$30,75 $34,73

(En stock)

This four gauge power cable is used on the robot to connect a 120 Amp Breaker (am-0282) and a Power Distribution Panel (am-2856) to a power component. This multi-strand wire is securely crimped and protected with heat shrink tubing. The tip-to-tip length is approximately five inches. This cable is used in the 4 Gauge Robot Power Cable Kit. Both end connectors of cable are crimped with a 6-ton pneumatic linkage crimping tool, and utilizes an Anderson SB120 for connecting to your power source.

Specifications:

Gauge: 4
Weight: 0.562 Pounds
Connector Type: Anderson SB120
Overall Length: ~14 in. (+/- 0.25 in.)
Red Wire Length (SB120 to Lug): ~ 9.5 in. (+/- 0.25 in.)
Black Wire Length (SB120 to Lug): ~ 16 in. (+/- 0.25 in.)

Nason Pressure Switch

#am-2006

$61,00

( 5 En stock)

This is an air pressure switch with a factory preset setting of 115-120 psi. This switch is able to send a signal to a robot controller, which can then tell a pneumatic compressor (air pump) to stop operating.