All AndyMark gearboxes require grease for proper operation and long life. We
suggest using our red tacky grease, am-2768. We also encourage that the user
powers the gearbox continuously for 30 minutes without grease to allow the gear
teeth to wear in. While we do design with short run times in mind, this 'run in'
period for smooth gearbox operation, is recommended. Once this is completed,
thoroughly grease the gear teeth periodically to ensure smooth operation.
Specifications:
- Weight: 0.55 pounds (without motor)
- Input: 0.125" dia. shaft
- Output: 8mm (0.313") dia. shaft, 2mm keyway
- Reduction Ratio: 5:1
- Max Output Torque: To be determined
- Gear Material: Steel
Included Hardware:
- One - Retaining Ring, 8mm id (am-0033)
- Two - Motor Plate for CIM-Sim Gearbox (am-0926)
- One - 60T 32DP 0.375" Hex Bore, Steel Gear (am-0927)
- Two - 12T 32DP 0.125" Round Bore, Steel Gear (am-0928)
- One - Output Shaft for CIM-Sim Gearbox (am-0930)
- Two - Ball Bearing, 8MMx19MMx6MM Flanged (am-0931)
- Four - 10-32 Nylock Nut - Bulk Qty (am-1042)
- One - 2x2x10 mm Machine Key, steel (am-1121)
- Four - 10-32 Self Clinching Flush Nut (am-1179)
- One - 3/16 Thick Nylon Spacer (am-1181)
- Four - 10-32 x 1-1/4" Self Clinching Stud (am-1239)
- Four - M3-0.5 x 6mm SHCS (am-1254)
- Four - 11/16 Thick Nylon Spacer (am-1255)