Studica Hubs
Replacement Hub for Studica Omni or Mecanum wheels so they can be used on 5mm Hex-Shafts.
Step File
Φ29.0mm*16.0mm thick
6*M3 thread tapping through
(including 2*M3 thread for M3 SHCS)
Φ6.0mm D hole
AL6061-T6
The Intake Kit can be used to create intake systems and is ideal for the FIRST Technical Challenge (FTC) and World Robotics Olympiad (WRO). Used with the Silicone Rubber Tubing #76410
Specifications:
Made of aluminum, the Studica Clamping Shaft Hub is used with flex and drive wheels
Specifcation:
The Studica Light Weight Shaft Hub is used with the 6mm D shafts. It has a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
Specifcation:
Used with Studica Omni and Mecanum wheels for a strong axel hold.
Specifications:
The 6mm Shaft hub is used to connect any Studica wheel and the Studica motor or any motor with a 6mm shaft.
Specifications:
The Studica Robotics 6mm Hex-Shaft Low Profile Clamping Hub is an ideal fit for our motors.
The Studica Robotics Clamping 6mm Hex-Shaft Hub is used with flex and drive wheels and is improved for the absolute strongest hold.
Made of aluminum, the Studica Robotics Clamping 7mm Hex-Shaft Hub is used with flex and drive wheels.
The Studica Robotics 6mm Hex-Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a Hex-Shaft axle.
The Studica Robotics enhanced wheel Hex-shaft hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold