JST VH 2-pin Motor Cable - 4 Pack, 50cm

Made of aluminum, the Studica Clamping Shaft Hub is used with flex and drive wheels 

Specifcation:

• Material: 6061-T6 Aluminum
• 6mm ID
• Hole pattern for connecting to structure
• Step File 

The Studica Light Weight Shaft Hub is used with the 6mm D shafts. It has a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

Specifcation:

• Material: 6061-T6 Aluminum
• 6mm D Shaft ID
• M3 tapped hole pattern for connecting to structure
• Step File

The Studica Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

Specifcations:

• Spline: 25 Tooth, 3.8mm deep
• Height: 9mm
• OD: 30mm
• Material: 6061-T6 Aluminum
• Step File

• 42.0mm*42.0mm*11.3mm thick
• 16*M3*8.0mm thread
• M3 pass through holes
• SHCS sit flush
• Material - AL6061-T6

This kit can be used in addition to the Compact Linear Slide to add an additional 12.18 inches of stroke .

Included Items:

• 1 - SAR330 Aluminum Slide (am-4837)
• 4 - 3 mm ID 12 mm OD Pulley Bearing (am-4836)
• 2 - M3-0.5 x 35 mm Socket Head Cap Screw (am-1671)
• 3 - M3-0.5 Nylock Nut (am-1023)
• 2 - M3 Female Threaded 9mm Long Hex Standoff (am-1733)
• 1 - M3-0.5 x 8mm Flat Head Cap Screw (am-1723)
• 4 - M3-0.5 x 5 mm Zinc Flat Head Cap Screw with Nylon Patch (am-1724)
• 1 - 14 inch Pulley Mount (am-5035)

The Studica Robotics Light Weight 6mm Hex-Shaft Hub (2 pack) are used with 6mm Hex shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

The Studica Robotics 6mm Hex-Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a Hex-Shaft axle.

The Studica 30T Servo 25T Spline Gear is used with the Studica Multi-Mode Smart Servo or Studica Multi-Mode Smart Servo 200.

Specifications:

• Material: Steel Hardened, Zinc plated
• Step File

High-strength and low-stretch cord that is ideal for actuating lifts and other linear mechanisms.This cord type minimizes the need for adjustments and re-tensioning after first assembly due to its low-stretch properties.

The 100mm (4") Flex Wheel can be used for intake systems and conveyors.

Specifications:

• Diameter:   100mm (4")
• Axial width:  25mm 
• Hub:  1/2" Inner Hex
• Inner Material: Molded Plastic in Yellow
• Outer Material: TPU Polyurethane in Green
• Outer Material Durometer: 35A
• Weight: 0.038kg
• Step File