Use the Dupont Single Pin - 4 wire - female to female cable with the Ultrasonic Distance Sensor

Specifications: 

• Dupont Single Pin
• 4 wire
• female to female cable
• Length: 50cm
• Gauge: 22AWG

Extend the reach of your MXP port by using this 8 inch cable to re-position you boards where you need them.

Features:

• Keyed male and female 34-pin connectors
• 28 AWG ribbon cable
• 34 conductor
• 8″ length

The Powerpole Extension Cable is 50cm long and 14AWG wire gauge to handle heavier loads.

This set of 12 pieces includes,

• 2 x 20cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 40cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 60cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 6 x 3pin Dupont male to male connectors

The Titan Cable Pack contains three cables. A 60cm CAN Wire for connecting the Titan Motor Controller to a CAN 2.0B capable device and two (idk the 50cm JST-VH to JST-VH cables for connecting 12VDC power to other devices such as the VMX or Servo Power Block.

• 2 - JST-VH to JST-VH cable
  • 50cm
• 1 - CAN Wire
  • 60cm

USB Cable, Type A to Type C, Blue, 1 Meter, male to male

Includes:

• 4 JST-GH to 4 Pin Dupont Cables (connects a VMX-pi GH signal connector to an external sensor or device).
• 1 battery adapter cable (connects a VMX-pi power connector to an external battery supply).
• 1 Wallwart cable (cable allows you to connect a VMX-pi to an external 12VDC Wallwart power supply).

The VMX GH-to-SH breakout board connects a 4-pin .1" standard connect (sometimes referred to as an "AMP connector").  The connector may either be a standard or a locking variety connector.

• Board Dimensions:  2" x .75" x .15"
• VMX-side Connector: JST-GH Connector, 4-pin
• External Connector:  AMP Male Connector w/support for locking tab (4-pin)

The VMX Wallwart Adapter cable connects a VMX power connector to an external 12VDC Wallwart power supply.

Detailed Specifications:

• Cable Length: 25 cm
• Wire Gauge: 20 AWG
• VMX-side Connector: JST-VH Wire Colors: Red (power), Black (ground)
• Wallwart-side Connector:  2.1mm inner diameter, 5.5" outer diameter, center-positive

The VMX Battery Adapter cable connects a VMX-pi power connectcor to an external battery supply.

Detailed Specifications:

• Cable Length: 25 cm
• Wire Gauge: 20 AWG
• Connector: JST-VH Wire Colors: Red (power), Black (ground)
• Wire Free-end:  stripped and tinned

The JST-GH to JST-GH Cable connects external sensors, breakout boards or other devices.

Detailed Specifications:

• Cable Length: 25 cm
• Connectors: 4-pin JST-GH (2)
• Wire Colors: Black, Red, Blue, Green

The 2-pin JST VH Cable is keyed and locking for improved reliability.