Fermer
toutes catégories
    filtres
    préférences
    Rechercher

    Power Drawbar for the Tormach PCNC 770

    Eliminate the need to hand-tighten your drawbar and install this Power Draw Bar on your PCNC 770 for lightning-fast tool changes with the push of a button.

     

    The power drawbar is designed for use with the Tormach Tooling System (TTS), but easily pivots away to allow manual tightening of the drawbar if necessary for conventional R8 tooling.

     

    • Requires 90 psi Air Supply (FRL unit recommended)
    • Designed for use with Tormach Tooling System (TTS) toolholders
    • Control Pendant (Standard) or Foot Pedal (Sold Separately) actuation
    • Multi-stack air-over-air pneumatic cylinder ram actuation
    • Does not load the Spindle Bearings
    • Easily Pivots for Manual drawbar tightening for R8 tooling
    • Integrates with Tormach ATC (sold separately)
    •  

    The Power Drawbar kit includes pneumatic cylinder assembly stack, drawbar, electronic control circuitry, push-button pendant, and all necessary pneumatic tubing and electronic wiring.

    # Pièce: 32436:
    $0.00
    Écrivez votre propre commentaire
    • Le produit peut être examinée que après l'achat
    • Seul les utilisateurs enregistrés peuvent écrire une critique
    • Mal
    • Excellent