Outils
errules are crimped on the metal contact rather than through the insulation like standard connectors. This means there is more contact between the wire strands and the contact point. This Ferrule can be crimped using the am-3739 crimp tool.
This item can only be purchased in multiples of 25
iCrimp Cable Lug Crimping Tool for Heavy Duty Wire Lugs,Battery Terminal,Copper Lugs AWG 8-1/0
Purpose: IWS-2412M open barrel crimper tool is designed to crimp non-insulated open barrel, OEM-style terminals. Perfect for servo lead connectors and some other RC crimp connectors.
IWS-2820M open barrel crimper tool is designed to crimp non-insulated open barrel, OEM-style terminals. Perfect for servo lead connectors and some other RC crimp connectors.
This bolt with pin is a replacement for the #35 chain break. This component does the work of pushing a pin out of a chain link.
This hot knife is a convenient way to seal the end of a fraying rope or melt the ends of Polybelt to make a loop.
This assembly is used to easily make custom lengths of Polybelt loops. A set of thumb screws are included to make clamping belt ends simple. The over-center linkage makes it easy to bring the melted belt ends together and hold in place while the belt cools. This makes installing a custom-length polybelt loop on your mechanism easier than ever. This tool can accept polyurethane belts up to 2 inches wide.
Usage:
1.) Place cut belt ends under the clamping plates with about 1/16 inch hanging toward the inside. If using 1 or 2 inch wide belt, align the sides to the alignment notches.
2.) Tighten the thumb screws on both sides until the belt is snug.
3.) Using a heat source like our Belt Welding Hot Knife (am-5284) heat up the belt ends until they start to melt.
4.) Once the ends start to melt, immediately close the clamp to press the melted ends together.
5.) When cool, loosen the thumb screws on the slotted sides of the clamp (note indicator holes for reference) and remove clamp from belt.