This extension cable has one male and one female connector and is 50 cm long. You will receive 2 cables.
The XT30 is keyed and locking for better reliability.
· 450mm Length
· 3 position
· TJC8 MH-FC on one end
· TJC8 FH-MC on the other end
· Twisted cable
· Colors: White, Red, Black (red in middle)
· 24AWG Guage
Used with Studica Omni and Mecanum wheels for a strong axel hold.
Specifications:
The Motor Mount Plate is used with the Maverick 12V DC Gear Motor (Part# 75001) to attach it inside the anyone of the U Channels 76010 to 76018. This is an example of a chassis with 4 motors mounted inside the U-Channel using a Motor Mounting Plate.
The 100mm (4") Flex Wheel can be used for intake systems and conveyors.
The 6mm Shaft hub is used to connect any Studica wheel and the Studica motor or any motor with a 6mm shaft.
This is a single sheet of 1/8 inch thick polycarbonate (PC) plastic, cut to a 24x24 inch square. This single sheet of PC will be shipped with the protective covering on both sides of the plastic sheet. Polycarbonate was invented in 1963 by Dan Fox at General Electric. GE's trade name for this plastic is LEXAN, but it also is sold under other trade names (Makrolon, Hyzod, Cyrolon). This material is NOT plexiglas or acrylic, as we don't suggest that you use that material on a mobile robot, since acrylic will easily shatter. Specifications:
Axle Hubs are used to attach gears and wheels to axles and axles to structural elements. Features heavy-duty aluminum construction.
The Studica Multi-Mode Smart Servo features all-steel gears and large amounts of torque. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
Type: Metal Brush Motor Horn Gear Spline: 25T (5.9mm) Size: 40mm x 20.1mm x 38.3mm Weight: 65g Maximum Speed: 62RPM at 6V Stall Torque: 20kg.cm at 6V Voltage: 6-7 4V Cable: 22AWG, 75cm