Hardware
Includes 6 bits,
The easy way to change the length of your #25 chain. (Chain not included)
Specifications:
The M3 T-Slot Nut 100 pack, is a Hammer Head Series 20 and is used with any M3 screw and fits the Studica T-Slot Extrusions.
This crimp tool is the ultimate Powerpole crimper. The jaws work for 15, 30, and 45 connectors. This crimp tool has a built-in positioner to hold the contacts during crimping. The ratchet mechanism assures proper crimps every time.
The 15 amp connector and be crimped with 16 28 and 20 AWG wire. The 30 amp connector can be crimped with 12 and 14 AWG wire. 45 amp connector can be crimped with 10-12 AWG wire.
Rubber Grommets are made for the Studica channel and plates and or any structure with a 14mm hole. Use it for protecting wire or as a bumper.
Specifications:
The Studica U-Channel Bumper is connected to the end of the Studica 48mm U-Channel and helps remove sharp corners that can cause damage when the robot is bumping into other objects. It also creates an ecstatically clean finish to your robot.
Specifications:
This kit includes the tools need to cut and join a urethane belt. Recommended for the 5mm Urethane Round Belt - part # 76400
Spare sets screws for Studica Robotics Hubs and Collars
10 Pack CONE HEX SOCKET SET SCREW DIN 914 M3 Thread
Made of Nylon, the Studica Rubber Foot is used with the Studica Robotics building structure and for many other uses.
Specifications:
Spare sets screws for Studica Gears Including:
76219 - 30 Tooth Bevel Gear
10 Pack CONE HEX SOCKET SET SCREW DIN 914 M4 Thread
The M3 x 10mm Low Profile Screw with Kep Nut is a 304 Stainless Steel m3 Din 7991 Countersunk Hex Socket Flat Head Screw with a matching Kep Nut. This package is made for the Slide Rail, 288mm Length, 180mm Stroke and the Slide Rail, 384mm Length, 240mm Stroke
Includes,
M3 x 25mm Socket Head Cap Screw (pack of 100), Zinc Plated.