AndyMark develops, manufactures, and distributes mechanical and electrical parts for the mobile and competitive robotics market, with a focus on robotics education. The AndyMark staff strives to support the FIRST Community and the robotics education market by developing and distributing important components to robot builders and for mobile robotics.
This is 12 GA bonded wire* with Red and Black Jacketing. It is much easier to use than two separate wires, easier to follow during troubleshooting, and easier to keep your wiring clean. Pull apart at the end only as much as you need and the rest stays together.
If you are looking for a much more flexible wire or wire that is not bonded check out our Silicone Wire.
This 120 Amp Circuit breaker forms the main circuit breaker for FIRST Robotics Competition robots. It can protect your robot or other system from drawing so much current that systems receive more damage. Of course, we highly recommend using circuit breakers downstream rated for less to protect your motors, speed controllers, and control system components.
Servo City's patented 32 pitch Hitec metal gears are designed to attach directly to the output spline of a servo. All gears are broached directly into the metal to ensure a snug fit that will not slip. These gears are designed to fit the standard 24 tooth Hitec output spline.
This 12 tooth pinion gear is designed to fit onto an AndyMark RedLine Motor (am-3775) and other motors with a 5 mm output shaft to interface with spur gearboxes such as the DeCIMate (am-3745), EVO Slim for RedLine and EVO Shifter for RedLine.
This gear is used as the input pinion gear for the EVO Shifter. This gear is a tight press fit onto a CIM gear, and requires at minimum a 3-ton arbor press to install. If a CIM motor with this gear pre-installed interests you, check out am-0255_15T.
Specifications:
Tooth Count: 15
Diametral Pitch: 32
Pressure Angle: 20
Pitch Diameter: 0.469"
Face Width: 0.531"
Thickness: 0.75"
Material: 1117 Steel
Bore: 0.312" Round (7.92mm) This is a press fit onto the CIM Motor (am-0255)
This pinion gear is designed to be pressed onto motors with a 5mm output shaft such as most 700 class motors. This pinion interfaces with our PG71 and PG188 gearboxes.