The Intake Kit can be used to create intake systems and is ideal for the FIRST Technical Challenge (FTC) and World Robotics Olympiad (WRO). Used with the Silicone Rubber Tubing #76410
Specifications:
The 60 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 40 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 80 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The GT2-6mm Timing Belt Clamp w/Set Screw is used with all the GT2 belts.
This GT2 (also called 2GT) timing belt has a 2mm Pitch and 6mm width
Used to change motor to axle motion 90 degrees. This can be used in between the U-channel.
The Studica 30T Servo 25T Spline Gear is used with the Studica Multi-Mode Smart Servo or Studica Multi-Mode Smart Servo 200.
These round groove pulleys are also referred to as U groove pulleys. They are made of 6061-T6 Aluminum with a D-Shaft hole through of 6mm, and 2 set screws for ultimate strength. Use it with the 5mm Round Belt and for gearing up or down combine them with the other round groove pulleys that range from 10mm to 60mm.
The 20 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 30 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing
Used with Maverick DC Motor with 6mm shaft and all 6mm D-Shaft Axels. Matching belt 10mm Timing Belt, # 76233.
The pulleys are .40” inside the flanges to allow for belts up to 3/8” in width. Two set screws using 1.5mm hex key.
Includes two 5mm Bore, 10 Tooth Aluminum Pulleys and one 1M XL Timing belt
GT2 PulleyΦ22.0mm*13.0mm thick2*M4 thread for M4 set screwsΦ6.0mm D hole
AL6061-T6