PRE-ORDER Only shipping January 2023
Φ20.0mm*8.0mm thick 2*M3 thread for M3 SHCS on the clamp side Φ6.0mm D hole AL6061-T6
Φ29.0mm*16.0mm thick 6*M3 thread tapping through (including 2*M3 thread for M3 SHCS) Φ6.0mm D hole AL6061-T6
Used with Studica Omni and Mecanum wheels for a strong axel hold.
Specifications:
The 60 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The NEW 40:1Tetrix Max; TorqueNADO Motor Gearboxes give more rpm when compared to the 60:1 gearbox included with the TorqueNADO motor. These gearboxes are designed with the same 37 mm diameter as the original 60:1 gearbox, while using the same 6 mm D-shaft and alignment pins, so getting the additional speed you need is a breeze.
GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing
#25 Connecting Link (Master Link) Specifications:
The Studica Light Weight Shaft Hub is used with the 6mm D shafts. It has a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
Specifcation:
These adapters are intended to be a high strength solution to adapt the Falcon Spline to any product that has a 1/2 in hex bore. This product includes the correct size washers to retain items along the hex shaft, as well as a thread-patch 8-32 screw to be used in conjunction with spacers included with the Falcon 500 motor to retain motion hardware.
The Studica Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.
Specifcations:
The Studica Servo Arm can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.
May be used with 6mm D-Shape Shaft to secure wheels in their position.
The D-Shaft Collar is 6mm ID and 12mm OD. The inside diameter will fit any of the D-Shaft axels.
Material: 6061-T6 Aluminum