These ring terminals are intended for securing 10-12 AWG wire to #8 sized terminals. These are superior to spade terminals, as they cannot loosen out of a terminal. We recommend the use of these terminals with the SPARK motor controller (am-4260). The terminal is superconductive copper that is tin-plated to resist wear.
This item can only be purchased in multiples of 10
This hub fits all AndyMark wheels, and the bore fits the shaft of our Snow Blower Motor.
The bolt pattern is designated as 6 holes evenly spaced on a 1.875" diameter bolt circle. The DD broach is consistently cut to be aligned with the holes.
This general purpose metric woodruff keys are not hardened, so they are easy to machine. They reach deep into the shaft keyway for a secure hold, yet their roundness allows them to rock in their seat to relieve stress on the shaft caused by vibration or misalignment. Specifications:
These round groove pulleys are also referred to as U groove pulleys. They are made of 6061-T6 Aluminum with a D-Shaft hole through of 6mm, and 2 set screws for ultimate strength. Use it with the 5mm Round Belt and for gearing up or down combine them with the other round groove pulleys that range from 10mm to 60mm.
These aluminum 5M HTD Pulleys work great for creating belt reductions directly off the motor. Use a 15mm wide belt or two 9mm wide belts as the inside pulley teeth are 18.5mm wide. Choose either 8mm keyed bore or spline bore depending on the motor type you're using.